This article is a comprehensive guide for wallpapering around unusual spaces, like windows, archways, outlets, faceplates, fixtures, thermostats, and more.
Wallpapering around an archway uses some of the same techniques as covering a solid wall.
Hanging Archway Strips
Hang two strips of paper that are as tall as the archway and as wide as the jamb; make a horizontal cut from the inside edge to within an inch of the wall.
Wrap the paper along the edge of the arch and down the jamb, smoothing out any wrinkles and bubbles as you go.
Trimming & Matching
Trim the paper on the archway with utility shears to within an inch of the edge. Cut small wedge shapes that extend 1/4 inch from the edge.
Calculate half the length of the arch, and then cut two strips to that length (plus a quarter inch) and to a width that is 1/4 inch narrower than the jamb. Apply the paper from the top down, and double-cut the seam.
Hanging paper around openings such as windows, outlets, and fixtures is similar to hanging paper on solid walls and uses many of the same techniques.
Papering Around Small Windows
1 Fit the paper
After you hang the paper around the window opening, trim it to about 2 inches longer than the width of the recessed area. Cut diagonal slits into the corners.
2 Apply matched side pieces
Smooth all the flaps down and then paste matching strips into each side, cutting each piece to about 1/4 inch narrower than the space.
Papering Around Large Windows
Mark a horizontal line above and below the window, using a carpenter’s level aligned with a design element in the strip you’re starting with (marked “1” on the diagram). Hang strips according to the diagram, following the sequence 2A, 2B, 3A, 3B, and finally 4.
You may need to make adjustments to strip 4 to match the surrounding pattern.
Papering Around Outlets
Shut off the power to any outlet you’ll be papering over, and remove the faceplate. Paper over the space as if it were a solid wall.
Then, use a utility knife to slice the paper from corner to corner. Trim the extra off and then fold the edges in. Replace the faceplate.
Papering a Faceplate
Paper over each faceplate before placing the faceplates back on walls. Sand and prime the front and measure a piece of wallpaper that is 1 inch longer on all four sides.
Apply vinyl-to-vinyl paste to both the faceplace and the paper. Hold the faceplate up to the outlet and attach the wallpaper so that it matches the pattern.
With the faceplace paper side down on a table, trim the border down to 1/2 inch and cut off the corners. Fold the paper around the plate and smooth the edges into the back. Use a utility knife to cut out the openings for the electrical plug and then replace the faceplate.
Wallpapering Around a Fixture
1 Slice the wallpaper
After turning off the electricity, removing the fixture, and covering it loosely with paper, slice the wallpaper from the ceiling line, baseboard, or corner, whichever is closer, to the opening.
2 Cut slits
Cut a series of slits from the fixture’s center to its outer edges until you can smooth down the paper around it.
3 Finish up
Crease the edges of the slits against the wall tightly, and then trim them with a razor or utility knife.
Wallpapering Around a Thermostat
To paper around a thermostat, hang the strip from the ceiling line as you would for any wall.
When you reach the thermostat, smooth the paper down as close to it as you can without tacking it onto the thermostat as shown at left.
Make an X-shaped cut over the thermostat large enough for the paper around it to lie flat, but not so large that the paper will show cut marks. Trim the excess, and then smooth the paper.
